need to add all the electronics servos,speed controller ,receiver and motor. then set everything to neutral and line all all the flaps, ruder, elevator and ailerons, set the pitch on the motor. lost of work left
he has my old RockChucker press and a older die set I gave him. Basically he only has a neck-sizing die and not a full lenghth re-sizing die. When neck sizing you have to be careful to not pull the shoulder of the brass case up when you raise the arm of the press. This will make the brass too long and cause the OAL(overall length) to be greater and out of spec. This can be caused by improper sizing lube or dirty carbide ball on the die. Won't know for sure til Fri when he brings me some dummy rounds he loaded and his die set..
