MAG254 Mode Not Supported Problem

[banar]

I played with resolution settings and after the reboot of my MAG254 I'm only getting "Mode Not Supported". The problem is that I cannot get into BIOS by holding menu button. I do know how to get into BIOS, as I've done it about 20x already. Any ideas on how to fix it?

Thank you.

 

[crazed 9.6]

take that mag to another TV , a newer TV
Then if you can see the menus and etc, go into menus and ensueit is not stuck in PAL mode and set the resolution down a notch or two.

Take back to your TV and check for results.

 

[banar]

take that mag to another TV , a newer TV
Then if you can see the menus and etc, go into menus and ensueit is not stuck in PAL mode and set the resolution down a notch or two.

Take back to your TV and check for results.

I tried, didn't work. Any other ideas?

 

[Bkman2020]

youtube has videos on to fix that issue

 

[Bkman2020]

Try This youtube video below.

https://youtu.be/4QYACOdiZDY

 

[banar]

Try This youtube video below.

https://youtu.be/4QYACOdiZDY

As I said, I'm not able to get into the BIOS this way. For whatever reason. Actually, I think I am in the BIOS, but the screen says mode not supported.

 

[Bkman2020]

do u have rca jacks that came with the box and rca connection on back of the tv?

 

[Heaven]

Open Bios on the Mag250/4 by removing the power from the Mag box. Then while holding down the Menu Key on the Remote Control plug the power back in. You will then see the BIOS screen on your TV Set.

 

[kallama]

Hi iam new with this box mag254 and subscribed with private provider, and he told me to make one url? Do they provide or we hav to make one for url portal? So confuse...

 

[banar]

I was able to do it via the RCA cable, no other way to get it done.

Thank you all.

 

[sugarmtn]

take that mag to another TV , a newer TV
Then if you can see the menus and etc, go into menus and ensueit is not stuck in PAL mode and set the resolution down a notch or two.

Take back to your TV and check for results.

had the same problem and this fixed it - thanks