MAG250 only works on some TVs

[gordymac]

I bought 2 MAG250 boxes, they don't work on my 55" TV, friends 50" TV or small 19" flat screen, either doesn't show anything at all or shows all scrambled.. we tried all the different display settings and still no luck, any ideas?

[DarkSide]

check out this link



http://iptvtalk.net/showthread.php?530-how-to-reset-your-box

[gordymac]

Already tried that, no luck.

[Bkman2020]

Did you go into the bios setup and adjust the resolution?

[gordymac]

Yep, still no luck, no difference... same on both boxes too

[Bkman2020]

Are those tv sets 4k?

[gordymac]

Nope, none of them are... Ive been trying to reset the bios, but now when I turn it on its just a blue screen says Loading... and shuts off after about a minute.. I tried to load new firmware via mcast the box says it was successfully loaded the image to flash but then just reboots and shuts off.

[Bkman2020]

If you get picture at the begining of boot process it is a video resolution issue.

[greg]

go in to bios set to video to auto it will work

[gordymac]

There is no auto in bios... right now if I turn it on it goes to blue screen by itself, says Loading... on bottom left and then about 30 seconds into it, it just shuts off... I tried NAND, NAND2, DHCP and it does the same

[xbmcbg]

If your MAG 254 is not bought from Infomir do not complain because you pay as much as you received (presumably you have " FF " in the MAC address -China copy)
If the box is original, follow instructions of Inform and it should work .

http://wiki.infomir.eu/doku.php/en:stb_webkit:faq:graphic_res_and_tv_system

[chad1976]

U need to look at the back of your tv. See what hurtz your tv is. And revolution. That should help u out