new mag 254 - no sound

[hog1945]

Hi Folks

I got my mag 254 working last night. I was browsing around trying to learn the system and after about an hour: the sound went out. I have been thru the internal and external portals trying to check everything out. Have checked the mute buttons on both mag and tv. Have even tried a second tv just in case, and rebooted a couple of times. No luck. Does anyone have any suggestions or did this box just go bad?

Thanks
Eddie

[sston]

Go into system settings in the inner portal , go in Audio, and see if the volume is at 100.
Also you could try switching hdmi cables or your rca cables to see if that helps.

[K00lKatT]

you can also boot into BIOS menu to check your audio there, also..

[crooks1705]

someone has a post on losing audio on mag254 I found it by reading because I lost audio on my mag I believe he said to go to video settings an turn off where it says to force dvi thte reboot then you should have audio on every channel hope this will help you it did me because I was at a loss about lousing audio I thought my mag went bad

[greg]

factory reset the mag 254 end start over it correct the no audio problem

[hog1945]

someone has a post on losing audio on mag254 I found it by reading because I lost audio on my mag I believe he said to go to video settings an turn off where it says to force dvi thte reboot then you should have audio on every channel hope this will help you it did me because I was at a loss about lousing audio I thought my mag went bad

Thank all of you for your response. It is much appreciated. I have posted 3 times for help here and been helped 3 times. Great group! I had already changed hdmi cords to no avail. Who would have known to enter into video to fix an audio problem per crooks comment. All was fixed in a couple of minutes. Too many drinks last night I guess.
Thanks to all again.
Eddie

[Marley]

Go to settings :video : Press f1 :hdmi/dvi enter hdmi than reboot

[daigia]

Go to settings :video : Press f1 :hdmi/dvi enter hdmi than reboot

Thank you for your big help without out your best instruction I will throw my Mag 254 away. Thanks :rolleyes:

[greg]

daigia have you check settings to make sure audio stereo out mode set to stereo end spdif mode set pcm end hdmi audio to pcm make sure they are correct

[chad1976]

Thank you for your big help without out your best instruction I will throw my Mag 254 away. Thanks :rolleyes:

Good god.U give up soon. Try a new hdmi cable.