Avov box not booting up

[legsdiamo]

My avov box is stuck in the booting mode, the blue circle just spins continuously for hours, any suggestions?

[smitty1952]

I had one box that did that. I had AV cables in I put the HDMI in ,then took update and was fine

[Marley]

video cable has nothing to do with internet unplug it for hr and try again but you never know with this box

[legsdiamo]

Got it up and running, thanks.

[smitty1952]

how did you get it running

[legsdiamo]

Unplugged the power supply, pressed in the reset button and simultaneously re-inserted the power supply and held for approximately 15 seconds then release. A diagnostic screen then comes up and you select the factory reset option and then reboot box.

[crazed 9.6]

Unplugged the power supply, pressed in the reset button and simultaneously re-inserted the power supply and held for approximately 15 seconds then release. A diagnostic screen then comes up and you select the factory reset option and then reboot box.

fantastic,
thnx legsdiamo :)

[vicvan]

ware is the reset button on avov1 ?

[BIO]

Mine is a small hole beside the power plugin.
Would take a paperclip or piece of coax to get in there.

[goosemanx]

Mine is a small hole beside the power plugin.
Would take a paperclip or piece of coax to get in there.

I use a steak knife

[BIO]

I'm scared to ask what technique you use with a steak knife.
Afraid it may be the same as for using a large hammer :)

[vicvan]

i can see a micro slot and that's it i got it fine paper clip did the job up again

[goosemanx]

I'm scared to ask what technique you use with a steak knife.
Afraid it may be the same as for using a large hammer :)
Haha, no bio two totally different results.
However i have felt like using the hammer on it several times.
Works pretty good for the most part, other than not totally booting up when updating

[omegamike]

where is the reset button on avov01?

mike

[omegamike]

I found it

mike

[Niteman]

Unplugged the power supply, pressed in the reset button and simultaneously re-inserted the power supply and held for approximately 15 seconds then release. A diagnostic screen then comes up and you select the factory reset option and then reboot box.

Thanks for the info its greatly appreciated.