Learning Remote Programming

[kens]

TV / Source Button Programming;

1. Press and hold [TV] for 5 seconds. The LED goes from blinking to solid
and STB Remote Control Unit will enter Learning Mode.
2. Press the Key to be programmed on T1 plus Remote Control Unit. LED
begins blinking slowly.
The key is now ready to accept programming.
3. Aim the TV Remote Control Unit towards the front of the Dreamlink T1
plus Remote Control Unit (the distance must be less than 3cm).
Press the button on the TV Remote control. If the T1 plus Remote Control
is programmed correctly, the LED will flash 3 times.
4. Repeat step 2-3 for other keys.
5. Exit Learning Mode by pressing any other button on the Dreamlink T1
Plus Remote Control. LED turns off.

/kens

[Capt.Kangaroo]

Thanks kens, very helpful post...