mag254 problem

[the2deez]

no signal
reboot, the imformir page, loading from nan,loading image , loading black screen loading, then tv no signal for device
can any one help

thank the2deez

[dreamscape]

Press 'setup' on remote, reload portal, wait to see if it works, if not repeat.

[the2deez]

can not load settings no responce blue light flashes nothing
thanks for the fast response
the2deez

[soldertech24]

Reboot unit hit menu on your remote while box is loading nowyour in bios look for boot change to nand2 save and exit.

[the2deez]

thanks for help
reboot already on nan2 exit blue screen no change
the 2deez

[soldertech24]

Most likely software is corrupted needs to get installed manually with usb stick.

[soldertech24]

1. Download 2 files
hxxp://soft.infomir.com.ua/mag254/re.../Bootstrap_254
hxxp://soft.infomir.com.ua/mag254/re...r7/imageupdate
2. On USB-drive, the file system FAT32, create a directory
mag250
3. Put files bootstrap and imageupdate to directory mag250 on USB flash
WARNING! This files must be named as
bootstrap
imageupdate
withoit extension!
4. Put your USB flash to rear USB connector on STB.
5. Unplug power of STB. Press and hold “Menu” button on RC (direct your RC to STB).
Plug power on STB with holding “Menu” button. Hold “Menu” button during 10 seconds.
You can see BIOS menu of STB.
6. Select “Upgrade Tools”, pressing enter on the remote control to the right
7. Select “USB Bootstrap”
8. Connect the USB flash drive and click OK to confirm the beginning of the update process
9. Wait for the update, STB will reboot.

[soldertech24]

Good luck!

[the2deez]

will try
not sure where to download files cant find a file download section
the 2deez

[Juliushell]

deez, if you see number one on soldertech post, there are the download links, just replace xx for tt.

[the2deez]

soldertech
sorry but i cant find the download
the links go nowhere

[the2deez]

thanks soldertech
i have tryed to location the files useing your link with no success help
the2deez

do you think a factory reset will be any value

[K00lKatT]

no need, boot to BIOS menu, make sure your on NAND not NAND2 and your video is NTSC, you can also update from there or from inner portal if you can bring it up in menu, thks..

[the2deez]

thanks koolkat
cant find a section to change video

[K00lKatT]

sorry, have my avov hooked up now and not my mag or I'd check for ya..

[soldertech24]

will try
not sure where to download files cant find a file download section
the 2deez

I coded the 2 links due to forum policy just delete xx`s and add tt thanks.

[Marley]

think thats dead was going to post that at one time do what koolkatt said