help config stalker

[John]

Donation 1 IPTV + Free IKS

I go to Stalker client
portal 1
mac address 00:1A:79:00:00:00
Time Zone leve
login Donation #
Password Donation #
Guide
Preference Prefer Provider
Cache Guide Data on
Cache Time 24
XMLTV
Scope Remote URL
ADVANCE
Tken blank
Serial # 12345678951111
Device Id kkjjhhgfdsswrrt
Device ID 2 blank
Signature Blank
is my config wrong


starts to load get authentication failed

[crazed 9.6]

00:1A:79:xx:xx:xx

should be

00:1A:78:xx:xx:xx

[John]

still says failed
for server address I have 2.nfpsserver.tv
on my donation paper it says
IPTV: 2iptvprivateserver.tv
IKS SERVER: 2.nfpsserver.tv (Dish ) 65.nfpserver.tv (Ciaro TV 50
Port:12010
Deskey

what is the input I should use for sever address

[ilan]

Yep, your MAC address was wrong. Make sure the MAC address you are using (00:1A:78:XX:XX:XX) to configure the client is the one you see at the Donation Checker. You have to create more credentials as well. Follow these directions except for the EPG section. That section doesn't have to be configured to the load the channels. We'll worry about channel loading first. The instructions will tell you which portal to use, depending on your version of Kodi.

http://iptvtalk.net/showthread.php?24831-PVR-Stalker-(Kodi-Built-in)-Set-up-tutorial

[John]

thanks for the help I just cant get it to work do I need to update something

[ilan]

If you are using Kodi 15, use the following...



http://2.iptvprivateserver.tv


If you are using Kodi 16 or greater, use this...



http://portal2.iptvprivateserver.tv/stalker_portal/c/index.html

[John]

when I go to checker I get
Status Active
remaining days 364
mac address 00:00:00:00:00:00

when I open Portal on my box it says mac address is 00:1A:79:00:00:00

[crazed 9.6]

when I go to checker I get
Status Active
remaining days 364
mac address 00:00:00:00:00:00

when I open Portal on my box it says mac address is 00:1A:79:00:00:00

your MAc is showing all zereos, will not work. You need to get a MAC linked there.
And use the server URL portal as ilan shows from above post #6

Your MAC needs to be fixed. It needs a prefix of 00:1A:78 and with 6 more digits attached.

http://www.miniwebtool.com/mac-address-generator/

[John]

so I made one of 00:1A:78 will that work

[ilan]

We won't know until you enter it at the Dobation Checker. If someone is already using it, you will get a response of Mac already in use. If that happens, change it a little until the Donation Checker reports Mac changed successfully.

[John]

I put in new mac address did not get any reply good or bad

[crazed 9.6]

go back to that same webpage and ensure the same MAC is still there, re-enter it if needed... and then perform an IPTV Reset , then you will see a message of success or failed

[John]

still no luck changed mac address did not say it was good or bad so will try again tomorrow thanks for the help I did go back tried to go to checker just keep asking if I am a robot

[crazed 9.6]

left click my name and send me a message and I can check on if it worked, or link if needed.
I will need the MAC and your number or email

[crazed 9.6]

you did get it change with success, but the last digit at the website shows a 7, while what you sent me shows a 1 as the last digit.

Leave it as a 7 at the website now, just change your MAc on the stalker to match.
I sent you a reply message.

[John]

Still can get my box to work .Would it be a good idea to uninstall kodi and reinstall clean version to see if it is just curupedted if so what is the best version to install

[ilan]

I doubt your installation is corrupted. Rather, there is most likely a configuration issue.

At this point, here is what I would do...

Disable PVR Stalker and set defaults. Shut down Kodi.

Go to the Donation Checker. Make sure all your settings look proper. Jot them down so you have them for re-configuring PVR Stalker later.

While at the Donation Checker, do an IPTV Reset.

Wait at least 15 minutes then restart Kodi, but do not enable the PVR. While disabled, configure the PVR following these directions to the letter:

http://iptvtalk.net/showthread.php?24831-PVR-Stalker-(Kodi-Built-in)-Set-up-tutorial

Once completed with the configuration, making sure everything is accurate and complies with the directions, enable the PVR.

[crazed 9.6]

John is using Kodi16+
so, ensure server URL is as below...

http://portal2.iptvprivateserver.tv/...l/c/index.html

[John]

Ok thanks will try soon as I can

[John]

I have shut down kodi and reset iptv will see what happens later

[crazed 9.6]

you may be better off doing what you yourself suggested awhile ago.
Uninstall that Kodi and install new. Then use the Stalker version that should be already included in that new Kodi install.
Start fresh.

[John]

you may be better off doing what you yourself suggested awhile ago.
Uninstall that Kodi and install new. Then use the Stalker version that should be already included in that new Kodi install.
Start fresh.

Ok I followed all instruction's and channels loaded TV working , but picture starts and stops every few seconds ( thank you all for the help )

[John]

tv loads but do you have to reload every time you turn it on or is there away to keep it loaded

[ilan]

Don't close Kodi or turn off the box and it will stay loaded.