How To do this .. restart movie

[kcmood]

I read awhile back on how to restart a movie at the point you had to turn it off and I can't find it again. Could someone point me to the post that was in? Thanks

[crazed 9.6]

I read awhile back on how to restart a movie at the point you had to turn it off and I can't find it again. Could someone point me to the post that was in? Thanks

yes, could we have that info again.
I read it too and can't find it again.
If anyone could post this for us, we will sticky it this time :)

thnx

['chasing...]

just hit the green button & select 'unfinished, then select desired movie..

[kcmood]

just hit the green button & select 'unfinished, then select desired movie..

I just tried the green button and my 254 does not show "unfinished" it shows "not ended". I clicked on that and then clicked on the movie and it started at the beginning. So, I just did like I normally do and used the fast forward until I got to the hour count that I left it at by clicking the "info"

[alphablondy]

not ended is the one

[kcmood]

not ended might be the one but it doesn't work for me. The movie started at the beginning instead of an hour and one hour where I shut it off

[iptv]

We used to have that but have lost it, now if you select "not ended", the movie starts from the beginning and not the point one left it.

[alphablondy]

that is an issue that should be resolved. if the movie freezes,it's a pain to start over from the beginning. I usually turn on Kodi and watch the rest of the movie problem free.

[kcmood]

For now you can still get back to where you were by doing what I do in post #4. Be sure and check the time you are going to stop it by clicking the info button.

[kcmood]

An added post to the above. When the movie freezes note the time into movie by clicking info, then exit, restart and immediately use the info with fast forward key to desired time and minute you stopped it at.

[Marley]

yea thats what i do but sometime its them they didnt get all movie had that happen to me a few times

['chasing...]

the above procedure worked fine 4 me before last sw-update.. as of now i get the same results as the rest of you. i suspect the feature will return in the future..