how can i reset 254 ???

[jrb3059]

will not boot up all the way if I unhook cat5 will come up but when hook back up and retry go black for 2 hr then will come to blue sceen and load bar then
stick there need help t/y

[K00lKatT]

follow reset instructions by Asft in stickeys, also read the next post by BIO
when done with that, first update if you haven't done so already, then find the set up by BIO in stickeys, thks

[jrb3059]

can I do a factory reset is so how to

[DarkSide]

http://iptvtalk.net/showthread.php?530-how-to-reset-your-box

[jrb3059]

don't know were menu is on rc

[BIO]

http://iptvtalk.net/attachment.php?attachmentid=296&d=1423839108

[K00lKatT]

see post #2 here....

http://iptvtalk.net/showthread.php?780-Mag254-Setup-Guide

[K00lKatT]

sorry, BIO...wasn't quick enough..

[jrb3059]

I get wrong image and dhcp error

[jrb3059]

t/y for all help but I am stuck on wrong image and dhcp error over and over how do I get out or is there a way to load with usb

[DarkSide]

what exactly are you doing when you enter the bios menu?

[jrb3059]

did reset and save

[DarkSide]

get into the bios menu and change the boot mode

[jrb3059]

look at post 1 that why I went to boot it was not coming all the way up

[DarkSide]

unhook that ethernet cable, did you make sure after you got into the bios menu to a factory setting that you did select exit and save?

[jrb3059]

yes that what I did and when I saved it rebooted came back with on blue screen and just reboots over and over

[DarkSide]

get back into the bios menu and change the boot mode

c/p

change boot mode DHCP/NAND/NAND2


Enter The BIOS.
Select “Upgrade Menu” , right click on the remote control.
Select “Boot Mode” and pressing the remote control right to set the boot mode DHCP, NAND or NAND2.
Select “Exit & Save” and press on the remote control to the right.
Confirm “OK”.

[jrb3059]

darkside that what I need how to get back in menu don't do it

left off when typing to you when hooked back up got in menu
boot in dhcp could walk me throught it t/y

[DarkSide]

Power off STB MAG200/250.
Press and hold the «menu» on the remote (or the power button on the front panel).
Without releasing the «menu» (or the power button on the front panel) Power on STB MAG200/250.

[jrb3059]

Darkside thanks for all the help i got it you the man

[jrb3059]

got reset done but still stop just past loading Portal go black and that all need help to get past Portal loading

[jrb3059]

is it just me is this bad